IP Router Command Reference
178 7705 SAR OS Router Configuration Guide
Details
If Index The interface index of the IP router interface
Virt If Index The virtual interface index of the IP router interface
Last Oper Chg The last change in operational status
Global If Index The global interface index of the IP router interface
Port ID The port identifier
TOS Marking The TOS byte value in the logged packet
If Type Network — the IP interface is a network/core IP interface
Egress Filter Indicates whether an egress IPv4 filter is applied to the interface
Ingress Filter Indicates whether an ingress IPv4 filter is applied to the interface
Egr IPv6 Flt Indicates whether an egress IPv6 filter is applied to the interface
Ingr IPv6 Flt Indicates whether an ingress IPv6 filter is applied to the interface
SNTP B.Cast False — the IP interface will not send SNTP broadcast messages
True — the IP interface will send SNTP broadcast messages
QoS Policy Indicates the QoS policy applied to the interface
Queue-group n/a
MAC Address The MAC address of the IP interface
Arp Timeout The ARP timeout for the interface, in seconds, which is the time that an
ARP entry is maintained in the ARP cache without being refreshed
IP Oper MTU The operational IP Maximum Transmission Unit (MTU) for the IP
interface
ICMP Mask Reply False — the IP interface will not reply to a received ICMP mask request
True — the IP interface will reply to a received ICMP mask request
Arp Populate Displays if ARP is enabled or disabled
LdpSyncTimer Specifies the IGP/LDP sync timer value
Strip-Label Indicates that the strip label is enabled or disabled
LSR Load Balance Indicates the LSR load balance
TEID Load Balance Indicates whether the tunnel endpoint ID (TEID) load balance is
enabled or disabled
Table 31: Show Detailed IP Interface Output Fields (Continued)
Label Description
To Next Page
Loading...
