Alcatel-Lucent 7705 - Page 192

IP Router Command Reference
192 7705 SAR OS Router Configuration Guide
static-arp
Syntax static-arp [ip-address | ip-int-name | mac ieee-mac-addr]
Context show>router
Description This command displays the router static ARP table sorted by IP address.
If no options are present, all ARP entries are displayed.
Max Advert Interval The maximum interval between sending router advertisement messages
Min Advert Interval The minimum interval between sending router advertisement messages
Managed Config True — DHCPv6 has been configured
False — DHCPv6 is not available for address configuration
Other Config True — there are other stateful configurations
False — there are no other stateful configurations
Reachable Time The time, in milliseconds, that a node assumes a neighbor is reachable
after receiving a reachability confirmation
Router Lifetime The router lifetime, in seconds
Retransmit Time The time, in milliseconds, between retransmitted neighbor solicitation
messages
Hop Limit The current hop limit
Link MTU The MTU number that the nodes use for sending packets on the link
Autonomous Flag True — the prefix can be used for stateless address autoconfiguration
False — the prefix cannot be used for stateless address
autoconfiguration
On-link flag True — the prefix can be used for onlink determination
False — the prefix cannot be used for onlink determination
Preferred Lifetime The remaining time, in seconds, that this prefix will continue to be
preferred
Valid Lifetime The length of time, in seconds, that the prefix is valid for the purpose of
onlink determination
Table 34: Show Router Advertisement Output Fields (Continued)
Label Description