IP Router Command Reference
194 7705 SAR OS Router Configuration Guide
static-route
Syntax static-route [family] [ip-prefix/prefix-length | preference preference | next-hop ip-address |
tag tag] [detail]
Context show>router
Description This command displays the static entries in the routing table.
If no options are present, all static routes are displayed sorted by prefix.
The following adapter cards support the full IPv6 subnet range for IPv6 static routes:
• 6-port Ethernet 10Gbps Adapter card
• 8-port Gigabit Ethernet Adapter card, version 2 and version 3
• 2-port 10GigE (Ethernet) Adapter card (on the v-port)
• 10-port 1GigE/1-port 10GigE X-Adapter card
For these cards, the supported route range for statically provisioned or dynamically learned routes is
from /1 to /128.
For all other cards, modules, and ports (including the v-port on the 2-port 10GigE (Ethernet) module),
the supported range for statically provisioned or dynamically learned routes is from /1 to /64 or is /128
(indicating a host route).
Parameters family — displays the specified router IP interface family
Values ipv4 — displays only those routes that have the IPv4 family
enabled
ipv6 — displays the routes that are IPv6-capable
ip-prefix/prefix-length — displays only those entries matching the specified IP prefix and prefix
length
Values ipv4-prefix a.b.c.d (host bits must be 0)
ipv4-prefix-length 0 to 32
Values ipv6-prefix x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x: [0 to FFFF]H
d: [0 to 255]D
ipv6-prefix-length {0 to 128} | {0 to 64 | 128}
Interface The IP interface name associated with the ARP entry
No. of ARP Entries The number of ARP entries displayed in the list
Table 35: Show Static ARP Table Output Fields (Continued)
Label Description
To Next Page
Loading...
