IP Router Command Reference
196 7705 SAR OS Router Configuration Guide
status
Syntax status
Context show>router
Description This command displays the router status.
Output The following output is an example of router status information, and Table 37 describes the fields.
Sample Output
*A:ALU-1# show router status
================================================================
Router Status (Router: Base)
================================================================
Admin State Oper State
----------------------------------------------------------------
Router Up Up
OSPFv2-0 Up Up
RIP Up Up
ISIS Up Up
MPLS Up Up
RSVP Up Down
LDP Up Down
BGP Up Up
Max IPv4 Routes No Limit
Max IPv6 Routes No Limit
Total IPv4 Routes 5
Total IPv6 Routes 0
ECMP Max Routes 1
Triggered Policies No
================================================================
*A:ALU-1#
Act N — the static route is inactive; for example, the static route is disabled
or the next-hop IP interface is down
Y — the static route is active
Next Hop The next hop for the static route destination
No. of Routes The number of routes displayed in the list
Table 36: Show Static Route Table Output Fields (Continued)
Label Description
To Next Page
Loading...
