EasyManua.ls Logo

Alcatel-Lucent 7705 - Page 258

Alcatel-Lucent 7705
532 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
VRRP Command Reference
258 7705 SAR OS Router Configuration Guide
Parameters ip-address — specifies an acceptable next-hop IP address for a returned route prefix from the
RTM when looking up the route-unknown route prefix
Values ipv4-address: a.b.c.d
ipv6-address: x:x:x:x:x:x:x:x[-interface]
x: [0..FFFF]H
interface: 32 chars maximum, mandatory
for link-local addresses
protocol
Syntax protocol {bgp | bgp-vpn | isis | ospf | rip | static}
no protocol
Context config>vrrp>policy>priority-event>route-unknown
Description This command adds one or more route sources to match the route unknown IP route prefix for a route
unknown priority control event.
If the route source does not match one of the defined protocols, the match is considered unsuccessful
and the route-unknown event transitions to the set state.
The protocol command is optional. If the protocol command is not executed, the comparison between
the RTM prefix return and the route-unknown IP route prefix does not include the source of the prefix.
The protocol command cannot be executed without at least one associated route source keyword. All
keywords are reset each time the command is executed, and only the explicitly defined protocols are
allowed to match.
The no form of the command removes protocol route source as a match criteria for returned RTM route
prefixes.
To remove specific existing route source match criteria, execute the protocol command and include
only the specific route source criteria. Any unspecified route source criteria is removed.
Default no protocol
Parameters bgp — defines BGP as an eligible route source for a returned route prefix from the RTM when
looking up the route-unknown route prefix. The bgp keyword is not exclusive from the other
available protocol keywords. If the protocol command is executed without the bgp keyword,
a returned route prefix with a source of BGP is not considered a match and causes the event
to enter the set state.
Note: The link-local IPv6 address must have an interface name specified. The global IPv6
address must not have an interface name specified.

Table of Contents

Other manuals for Alcatel-Lucent 7705

Related product manuals