Alcatel-Lucent 7705 - Page 351

Filter Policies
7705 SAR OS Router Configuration Guide 351
dst-port
Syntax dst-port {lt | gt | eq} dst-port-number
dst-port range start end
no dst-port
Context config>filter>ip-filter>entry>match
config>filter>ipv6-filter>entry>match
Description This command configures a destination TCP or UDP port number or port range for an IP filter match
criterion.
The no form of the command removes the destination port match criterion.
Default n/a
Parameters lt | gt | eq — use relative to dst-port-number for specifying the port number match criteria:
lt specifies that all port numbers less than dst-port-number match
gt specifies that all port numbers greater than dst-port-number match
eq specifies that dst-port-number must be an exact match
dst-port-number — the destination port number to be used as a match criteria expressed as a
decimal integer
Values 1 to 65535
start end — specifies an inclusive range of port numbers to be used as a match criteria. The
destination port numbers start and end are expressed as decimal integers.
Values 1 to 65535
etype
Syntax etype 0x600...0xffff
no etype
Context config>filter>mac-filter>entry>match
Description This command configures an Ethernet type II Ethertype value to be used as a MAC filter match
criterion.
The Ethernet type field is a 2-byte field used to identify the protocol carried by the Ethernet frame. For
example, 0800 is used to identify IPv4 packets. The Ethernet type II frame Ethertype value to be used
as a match criterion can be expressed as a hexadecimal (0x0600 to 0xFFFF) or a decimal (1536 to
65535) value.
The Ethernet type field is used by the Ethernet version-II frames.
The no form of the command removes the previously entered etype field as the match criteria.
Default no etype