Alcatel-Lucent 7705 - Page 371

Filter Policies
7705 SAR OS Router Configuration Guide 371
Parameters ip-address — the IPv4 address to be matched
Values 0.0.0.1 to 255.255.255.255
src-port
Syntax src-port {lt | gt | eq} tcp/udp port range start end
src-port range start end
no src-port
Context config>security>policy>entry>match
Description This command configures a source protocol TCP or UDP port number or port range for the match
criteria.
The no form of the command removes the source port match criteria.
Default no src-port
Parameters lt | gt | eq — use relative to tcp/udp port for specifying the port number match criteria:
lt specifies that all port numbers less than tcp/udp port number match
gt specifies all port numbers greater than tcp/udp port number match
eq specifies that tcp/udp port number must be an exact match
tcp/udp port — the source port number to be used as a match criteria, expressed as a decimal
integer
Values 1 to 65535
start end — specifies an inclusive range of port numbers to be used as a match criteria. The
destination port numbers start and end are expressed as decimal integers.
Values 1 to 65535
profile
Syntax profile {profile-id | profile-name}
no profile
Context config>security>policy>entry
Description This command assigns an already configured profile to a policy.
The no form of the command removes the assigned profile.
Default 1
Parameters profile-id — specifies the ID of the profile group
Values 1 to 65535