Route Policies
7705 SAR OS Router Configuration Guide 465
to
Syntax [no] to
Context config>router>policy-options>policy-statement>entry
Description This command creates the context to configure export policy match criteria based on a route’s
destination or the protocol into which the route is being advertised.
If no condition is specified, all route destinations are considered to match.
The to command context only applies to export policies. If it is used for an import policy, match criteria
is ignored.
The no form of the command deletes export match criteria for the route policy statement entry.
area
Syntax area area-id
no area
Context config>router>policy-options>policy-statement>entry>from
Description This command configures an OSPF area as a route policy match criterion.
This match criterion is only used in export policies.
All OSPF routes (internal and external) are matched using this criterion if the best path for the route is
by the specified area.
The no form of the command removes the OSPF area match criterion.
Default n/a
Parameters area-id — the OSPF area ID expressed in dotted-decimal notation or as a 32-bit decimal integer
Values 0.0.0.0 to 255.255.255.255 (dotted-decimal), 0 to 4294967295
(decimal)
To Next Page
Loading...
