IP Router Command Reference
98 7705 SAR OS Router Configuration Guide
Local DHCP Server Commands
dhcp
Syntax dhcp
Context config>router
config>service>vprn
Description This command enables the context to configure local DHCP server parameters.
local-dhcp-server
Syntax local-dhcp-server server-name [create]
no local-dhcp-server server-name
Context config>router>dhcp
config>service>vprn>dhcp
Description This command creates a local DHCP server instance. A local DHCP server can serve multiple
interfaces but is limited to the routing context in which it was created.
The no form of the command removes the local DHCP server instance.
Default n/a
Parameters server-name — the name of the local DHCP server
Values up to 32 alphanumeric characters
create — keyword is mandatory when creating a local DHCP server
force-renew
Syntax [no] force-renew
Context config>router>dhcp>local-dhcp-server
config>service>vprn>dhcp>local-dhcp-server
Description This command enables the sending of FORCERENEW messages. If the DHCP server sends a unicast
FORCERENEW message to the client, upon receipt of the message, the client will change its state to
the RENEW state and will then try to renew its lease according to normal DHCP procedures.
The no form of the command disables the use of FORCERENEW messages.
Default no force-renew
To Next Page
Loading...
