Programming your telephone
8AL91432ENAD ed01.1 63/94
3.15 Programming an appointment reminder
You can set the time of a temporary reminder (one within 24 hours) or a permanent reminder (every
day at the same time).
• Reach the 'Menu' page.
• Appointment
• Enter time of appointment.
• Temporary/ Permanent
→
Select the type of appointment (temporary or permanent).
•
The 'Appointment programmed' icon is displayed on the welcome page.
At the programmed time, your phone rings:
•
If your calls are forwarded to another terminal, the forward is not applied to the reminder call.
To cancel your reminder request:
• Reach the 'Menu' page.
• Appointment
• Temporary/ Permanent
→
Select the type of appointment (temporary or permanent).
• Clear
•
The 'Appointment programmed' icon disappears from the welcome page.
3.16 Install a USB accessory (Headset, Handsfree, Loudspeaker)
• Connect the accessory to the USB connector (USB-A, USB-C).
• When you plug the accessory in the USB port, the USB accessory is automatically detected. If
an another accessory is already connected with the same function, a popup asks you to select
your preferred accessory to use for this function
3.17 Install a RJ9 headset
It is possible to connect a compatible RJ9 headset to the desk phone instead of the handset. An RJ-9
adapter may be necessary, depending on the RJ-9 headset.
3.18 Activating/Deactivating 'Forced headset' mode
Forced headset mode must be activated as soon as a headset is installed instead of the handset.
• Reach the 'Menu' page.
• Settings
→
Phone
→
ForcedHead
• ON/OFF: Activating/deactivating forced headset.
To Next Page
Loading...
