Guarantee and clauses
8AL91432ENAD ed01.1 90/94
Cleaning and disinfecting
Refer to document: “How to clean and disinfect Alcatel-Lucent Enterprise terminals”.
Wear gloves when cleaning products.
Do not use harsh chemicals such as bleach, peroxide, acetone, ethyl acid, methyl chloride, ammonia,
or multi-purpose cleaners to clean plastic, metal, rubber, or screen surfaces.
Wipe products with a clean, dry, microfiber non-abrasive cloth.
Spray cleaning solution on the cloth before cleaning the product.
Use pre-moistened wipes or dampen (but do not wet) a soft sterile cloth with the approved agent.
Never spray or pour chemical agents directly onto the device as the liquid may stain the product or
seep inside and damage the hardware.
Do not allow liquid to pool.
ALE recommends using a 70% ethanol solution for all wired and wireless ALE terminals.
Daily disinfection: Up to 5 disinfections per day.
Extensive wiping during cleaning or disinfection may cause surface damage to the device.
ALE recommends assigning a dedicated wireless terminal to each employee rather than sharing
shifts on terminals, as well as replacing the handset on wired terminals for each employee.
Cleaning mode provides a safe cleaning experience without compromising the phone's functionality
(see: Cleaning mode).
Power supply
ALE-20, ALE-20h, ALE-30, ALE-30h: these products can be supplied by PBX through proprietary Digital link
(excluding ALE-20/ALE-30) or by Power over Ethernet (POE) compliant with IEEE 802.3af class 1 minimum,
or by an USB Type C External Power Supply (EPS) with rating 5V DC, 2A minimun.
POE and USB Type-C EPS shall comply with IEC/EN/UL/CSA 62368-1 standard and relevant
regulations/standards applicable in the country of intended use and shall also be certified as a Limited
Power Source (LPS).
To Next Page
Loading...
