ALLEN & HEATH CQ-12T User Manual

 119
User Guide V1.1.0 Issue 1
RECORD / Multitrack
Record or Playback individual signals to and from individual channels using an
SDHC card.
 USB-A audio/data and SD recording/playback features utilise the same system
resources and cannot be used at the same time.
 Meters switch automatically to show either signal being recorded or played.
Set where input channel signal is recorded from (the tap-off point) and assign the
last pairs of channels to be recorded in the CONFIG / USB/SD/BT / USB/SD
screen.
Arm – Use the button under each channel meter to choose whether the channel
will be recorded. Armed channels are indicated with a red record symbol. If a
channel is armed but cannot be recorded with the current settings or connected SD
card, this is indicated with an exclamation mark.
Select Track - Select a multitrack to be played back.

ALLEN & HEATH CQ-12T Specifications

General

Phantom power	48 V
AC input voltage	100 - 240 V
AC input frequency	50/60 Hz
Power consumption (typical)	35 W
Frequency range	20 - 20000 Hz
Channels quantity	12 channels
Supported sample rates	96 kHz
Digital sound processing	- bit
Built-in display	Yes
Output impedance	75 Ω
Compatible memory cards	SD
XLR out	2
RJ-45 ports quantity	1
Number of microphone inputs	10
DJ mixer	-
USB connector type	USB Type-A, USB Type-B

Weight and Dimensions

Depth	242 mm
Width	291 mm
Height	89 mm
Weight	2400 g
Package depth	305 mm
Package width	370 mm
Package height	190 mm
Package weight	3200 g