Allen-Bradley Rockwell Automation 1734-AENT - Support of Rack-optimized and Direct Connections; Mix Rack-optimized and Direct Connections

1 Publication 1734-UM011A-EN-P - February 2004
Chapter 2
Install the 1734-AENT Adapter
What This Chapter Contains
This chapter describes how to physically install the 1734-AENT adapter on the
DIN rail and connect it to the EtherNet/IP network. The following table lists
where to find specific information.
Topic See Page
Identify Module Components 2-2
Mount the Adapter on a DIN Rail Before Installing Modules 2-2
Mount (or Replace) EtherNet/IP Adapter to an Existing System 2-3
Wiring 2-4
Mounting Dimensions 2-5
ATTENTION
You must use Series C POINT I/O modules with the
1734-AENT adapter. Series A or B POINT I/O
modules will not work with this adapter.