EasyManuals Logo

Allen-Bradley Rockwell Automation 1734-AENT User Manua

Allen-Bradley Rockwell Automation 1734-AENT
156 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #34 background imageLoading...
Page #34 background image
Publication 1734-UM011A-EN-P - February 2004
3-6 Configure the 1734-AENT Adapter for Your EtherNet/IP Network
Set the Network Address
You can set the network Internet Protocol (IP) address 3 different ways:
1. Using the thumbwheel switches located on the module
2. Using a Dynamic Host Configuration Protocol (DHCP) server, such as
Rockwell Automation BootP/DHCP
3. Retrieving the IP address from nonvolatile memory.
The adapter reads the thumbwheel switches only at powerup to determine if
the switches are set to a valid number. Press either the + or - buttons to change
the number. Valid settings range from 001 to 254. When the switches are set to
a valid number, the adapter’s IP address will be 192.168.1.xxx (where xxx
represents the number set on the switches). The adapter’s subnet mask will be
255.255.255.0 and the gateway address is set to 0.0.0.0. The adapter will not
have a host name assigned, or use any Domain Name System when using the
thumbwheel settings.
If the switches are set to an invalid number (i.e. 000 or a value greater than
254), the adapter checks to see if DHCP is enabled. If DHCP is enabled, the
adapter requests an address from a DHCP server. The DHCP server will also
assign other Transport Control Protocol (TCP) parameters.
If DHCP is not enabled, the adapter will use the IP address (along with other
TCP configurable parameters) stored in nonvolatile memory. The factory
default switch setting is 999, and DHCP is enabled.
Module
Status
Network
Activity
Network
Status
1734-AENT
PointBus
Status
Field
Power
System
Power
02
0
43248
Network Address
Thumbwheel
Press either the + or -
buttons to change the
number.

Table of Contents

Other manuals for Allen-Bradley Rockwell Automation 1734-AENT

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Allen-Bradley Rockwell Automation 1734-AENT and is the answer not in the manual?

Allen-Bradley Rockwell Automation 1734-AENT Specifications

General IconGeneral
Model1734-AENT
CategoryNetwork Hardware
TypeEtherNet/IP Adapter
Ethernet Ports2
IP AddressingStatic or DHCP
Network AddressConfigurable via software
MountingDIN rail
Number of Ports2
Port TypeRJ45
Communication ProtocolEtherNet/IP
ManufacturerRockwell Automation
Power Supply24V DC
EnclosureOpen-style

Related product manuals