Name: Allen-Bradley Rockwell Automation 1734-AENT
Brand: Allen-Bradley
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Publication 1734-UM011A-EN-P - February 2004

Configure the 1734-AENT for Direct Connection in RSLogix 5000 4-3

Create the

Example Application

Perform the following steps to create the example application:

1. Start RSLogix 5000 Enterprise Series. The RSLogix 5000 Main

Window will open.

2. From the File menu, select New.

The New Controller pop-up window will open.

3. Enter an appropriate Name for the Controller, e.g.,

“POINT_IO_Controller.”

4. Select the correct Version, Chassis Type and Slot number of the

Logix5555 controller, and the folder where you want to save the

RSLogix 5000 file (Create In). The Description is optional.

Note: Version 11 of RSLogix 5000 lets you choose to enable

redundancy. This example does not use redundancy. If you are going to

use redundancy in your system, check the Redundancy Enabled box so

that a check mark appears.

Other manuals for Allen-Bradley Rockwell Automation 1734-AENT

Questions and Answers:

Need help?

Do you have a question about the Allen-Bradley Rockwell Automation 1734-AENT and is the answer not in the manual?

General