Publication 1734-UM011A-EN-P - February 2004
5-8 Configure the 1734-AENT for Direct Connection and Rack Optimization in RSLogix 5000
The following window will open:
5. Verify that the Requested Packet Interval (RPI) is appropriate for your
system (10 ms for this example). This will be used for the rack
optimized connection to the I/O modules.
6. Click on the Finish button to accept the configuration.
The 1734-AENT adapter will appear indented under the local 1734-ENBT
in the I/O Configuration folder.
Add the POINT I/O Module and Configure For Direct Connection
1. Highlight the 1734-AENT under I/O configuration, right click and
select New Module.
2. Choose the 1734-OW2/C from the list of modules.
IMPORTANT
To avoid overloading the 1734-AENT, it is recommended
that the RPI be no less than 10 ms for rack connections
and 50 ms for direct connections.
IMPORTANT
If the 1734-AENT chassis size is exceeded, (i.e., you try
to add more modules than you configured) the New
Module selection will be dimmed out and disabled. You
will not be able to add any more POINT I/O modules
until the 1734-AENT chassis size is increased.
To Next Page
Loading...
Need help?
General
