Name: Allen-Bradley Rockwell Automation 1734-AENT
Brand: Allen-Bradley
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Publication 1734-UM011A-EN-P - February 2004

3-8 Configure the 1734-AENT Adapter for Your EtherNet/IP Network

The device will be added to the Relation List, displaying the Ethernet

Address (MAC) and corresponding IP Address, Hostname and Description

(if applicable).

When the address displays in the IP Address column in the Request

History section, it signifies that the IP address assignment has been

made.

4. To assign this configuration to the device, highlight the device in the

Relation List panel and click on the Disable BOOTP/DHCP button.

When power is cycled to the device, it will use the configuration you

assigned and not issue a DHCP request.

Note: To enable DHCP for a device that has had DHCP disabled, highlight

the device in the Relation List and click on the Enable DHCP button. You

must have an entry for the device in the Relation List panel to re-enable

DHCP.

Other manuals for Allen-Bradley Rockwell Automation 1734-AENT

Questions and Answers:

Need help?

Do you have a question about the Allen-Bradley Rockwell Automation 1734-AENT and is the answer not in the manual?

General