3. Press the START (enter) keypad when the desired status ap-
pears in the display. The next Cycle Segment option, SPIn,
will appear in the display.
NOTE: To program SPIn (Extract Step), continue to
next Cycle Segment option. To program other op-
tions press the #3 (∧) or the #6 (∨) keypads and refer
to the appropriate section.
Programming Extract Step
1.
When SPIn appears in the display, press the START (enter)
keypad. The first Extract step programming option will ap-
pear in the display.
2. Press the #3 (∧) or the #6 (∨) keypad to scroll through the pro-
grammable Extract step options. Refer to Table 9 .
NOTE: Extract Step SPEn must be enabled to scroll
through all Extract Step options.
3. Press the START (enter) keypad when the desired option ap-
pears in the display. The current status/value will appear in
the display. Refer to Table 9 .
Extract
Step Description Status/Value
SPEn
Extract Step Ena-
ble/Disable
on/oFF
SSEC
Extract Seconds 0-59
SnIn
Extract Minutes Intermediate Ex-
tract:
Min. Step Time = 30
seconds
Max. Step Time =
3:59 minutes
Final Extract:
Min. Step Time = 30
seconds
Max. Step Time =
9:59 minutes
Table 9 continues...
Extract
Step Description Status/Value
SSPd
Extract Speed
(G) (Design 1-
VFD only)
1 = Very low (80)
2 = Low (80)
3 = Medium (100)
4 = High (120)
5 = Very high (140)
Extract Speed
(G) (Design 2
and 3-VFD only)
1 = Very low (27)
2 = Low (80)
3 = Medium (100)
4 = High (125)
5 = Very high (150)
6 = Ultra high (200)
Table 9
4. Press the #3 (∧) or the #6 (∨) keypad to change the current
status/value.
5. Press the START (enter) keypad when the desired status/value
appears in the display. The next Cycle Segment step option,
SEg2 will appear in the display.
NOTE: To program Cnin (Cycle Time), continue to
next Cycle Segment option. To program other op-
tions press the #3 (∧) or the #6 (∨) keypads and refer
to the appropriate section.
How to Program Cycle Time
Cnin
This option allows the owner to program minutes to the cycle’s
display time
1. Press the #3 (∧) or the #6 (∨) keypad to scroll through the pro-
grammable Cycle Programming options until Cnin appears
in the display.
NOTE: The option PCtd Programmable Cycle Time
Display must be programmed on to access the Cnin
option, refer to Programmable Cycle Time Display PCtd.
2.
When Cnin appears in the display, press the START (enter)
keypad. The first cycle time value will appear in the display.
3. Press the #3 (∧) or the #6 (∨) keypad to change the current
value.
NOTE: The Program Cycle Time can be set from 0 to
255 minutes. The default value is 0.
4. Press the START (enter) keypad when the desired cycle time
value appears in the display.
NOTE: Programming display time (in minutes) does
not actually change time in the cycle, only to the
displayed cycle time for the user.
Programming Control
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
39 Part No. F8238101ENR11
To Next Page
Loading...
