Diagnosing Failure 60
4. Check drum rotation direc-
tion.
The drum must start rotating
upwards after pressing the
Start button, except for 36 and
50 kg models with Pullman
drum, where it must start rotat-
ing downwards.
Table 91
Failure 77: Time for Heating Blocking is Out
If external wait function in Initialization menu is set to Heating
and external blocking signal stays high for more then 1 hour then
error 77 is generated.
Diagnosing Failure 77
1. Check if the external block-
ing system operates correctly.
Repair external blocking Sys-
tem in case of failure.
2. Check if the wiring of the
input signal "On Hold" is not
damaged.
If the wiring is damaged: re-
pair the wiring.
3. Check the wash computer.
(Inputs can be checked one by
one in the Service Menu).
If the input of the wash com-
puter is not functional, replace
the wash computer.
Table 92
Failure 80: Time for Dispensing Liquid Detergents
is Out
Failure 80 occurs when the On Hold Signal of the Liquid Supply
Central Dispensing System stays high for more then 1 hour. At
Input 16 of the wash computer, the Liquid Supply Central Dis-
pensing System sends a "High" signal. This makes that the wash-
ing machine wait (at the Wash Sequence) to add Liquid Supply. It
will until the Liquid Supply Central Dispensing System has
pumped its liquid supplies inside the washing machine. When the
On Hold signal is "LOW" the wash program is NOT put On
Hold.
When the On Hold signal is "HIGH" the wash program is put On
Hold.
In normal operation the On Hold Signal of the Liquid Supply
Central Dispensing System must not stay high for more than 1
hour, as otherwise the machine will not finish the running wash
cycle anymore.
Diagnosing Failure 80
1. Check if the Central Soap
Dispensing System operates
correctly.
Repair Liquid Supply Central
Dispensing System in case of
failure.
2. Check if the wiring of the
input signal "On Hold" is not
damaged.
If the wiring is damaged: re-
pair the wiring.
3. Check the wash computer.
(Inputs can be checked one
by one in the Service menu)
If the input of the wash com-
puter is not functional, replace
the wash computer.
Table 93
Failure 85: RTC Low Battery
Failure 85 occurs when there is no battery available at the real
time clock, or if the power of the battery is too small to make the
real time clock run correctly.
Diagnosing Failure 85
Replace the CPU board.
Failure 95: Watch Dog
If the watch dog has been activated, message 95 is logged in the
Error log register. If this occurs often, ask the help of a techni-
cian.
Failure 106: Calibration Error
Failure 106 occurs, when the calibration result does not corre-
spond to the pre-set intervals. A different value is required for
each machine model and power supply type.
Troubleshooting
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
102 Part No. D1676ENR11
To Next Page
Loading...
