EasyManua.ls Logo

Alliance Laundry Systems PA20 X CONTROL - The Spray Sequence

Alliance Laundry Systems PA20 X CONTROL
110 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
The Soak Sequence
Display Mes-
sage Default Information Limits
Temperature 104° F [40° C] The water temperature. 33.8 - 113°F [1 -
45° C]
Inlet I1-I7 The suggested inlet valves are related to the temperature and the soap
box to be used.
NOTE: If you insert other inlet valves than the suggested
ones, problems can occur at the water fill process.
I1...I8
Level Normal Low The suggested water level depends on the machine Type. Refer to Table 6
RPM - The suggested RPM depends on the machine Type. Refer to Table 7
Detergents
Menu…
Supply 1, …, 8
0 seconds Time selection for Soap Boxes (hopper) and external liquid soap sup-
plies.
You can program up to 4 supplies at the same time. If you have pro-
grammed more then 4 supplies an error message will be generated.
Put the time of the supplies back to zero until not more than 4 non-
zero time values are remaining.
(liquid soap supplies must be switched on at the configuration menu) .
0 - 99 seconds
On Time 12 seconds The wash action (motor "On" Time).
(The suggested default values can be adjusted at the Initialization
menu)
1 - 99 seconds
Off Time 10 minutes The wash action (motor "Off" Time).
(The suggested default values can be adjusted at the Initialization
menu)
1 - 99 minutes
Time 1.0 Hour The Soak Sequence Time.
(for 0 Hour the Soak sequence will be skipped) (programmable in
steps of 0.1 Hour)
0 - 25.5 Hour
Pause No When a signal Pause is programmed, a pause will be introduced at the
end of the Wash Step. This allows the operator to add soap for the next
step. A buzzer signal warns the operator that the cycle has been inter-
rupted.
No / Yes
Table 30
The Spray Sequence
Prewash
Wash
Cooldown
Rinse
Extra Rinse
Final Rinse
Soak
Spray
No wash
Water or Liquid is injected at Distribution or Low Spin
Speed .
No standard water inlets can be programmed in this function.
The liquid will be injected based on soap supply program-
ming.
Programming
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
58 Part No. D1676ENR11

Table of Contents

Other manuals for Alliance Laundry Systems PA20 X CONTROL

Related product manuals