Alliance Laundry Systems PA20 X CONTROL - Faults Menu (Service Faults)

• Turn the washing machine to the setup mode. Refer to How to
Get into the Setup Mode.
• The Main menu is now available.
• Press the ARROW DOWN button to select the SERVICE
menu.
• Press the ENTER button to make your selection.
• Now you will see the Service Menu Screen.
Software version: 772.100.0
135 FX 1075 RPM
Diagnostic prog ...
Faults …
Toolbox …
Service menu
Hlavní menu
CHM1693R
Exit ...
Figure 31
The software version will be displayed in the following format:
"Software XXX Version: 772.100.0."
Faults Menu (Service Faults)
Faults Menu (Service Faults)
Display Message Information
View Fault Messages … Check the last 20 fault messages from the Err log.
(If no messages are displayed, this means that no Errors have occurred.)
E XXX : The Error message number.
YYYYYYYYYYYY : The Error message name.
1 Fault 1: E XXX: YYYYYYYYYYYY Fault Nr. 1: the last occurred error message.
… ...
20 Fault: E XXX: YYYYYYYYYYYY Fault Nr. 20: the last - 20 occurred error message.
Erase Fault Messages No The Error log is reset by erasing the Fault Messages.
Table 54 continues...
Troubleshooting
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
85 Part No. D1676ENR11