Alliance Laundry Systems PA20 X CONTROL - Step 4: Programming the Wash Part; Selecting the Wash Part

Step 4: Programming the Wash Part
CFD1355R_SVG
Program 1: Hot Intens
Step 2
Wash Spin
Time: 8.0 min
5
8.0 [4.0-20.0]
8 7 6
5
4
3
2
1
1. Step number
2. Program number + name
3. STEP Wash « » Spin part
4. Menu item
5. Value menu item
6. Original value
7. Limits menu item
8. Position menu item
Figure 20
This paragraph gives a detailed explanation about program-
ming the Wash Sequences.
• Each program step contains a wash part and a drain/spin part.
• First the wash part must be selected, item by item can be pro-
grammed.
• Next the drain/spin part must be selected, item by item can be
programmed. Refer to section Step 5: Programming the Drain
Step.
• Without making changes you can watch item by item, by
pressing the ARROW DOWN or UP button.
• If you want to make changes:
• Insert a new value.
• Enable or disable a Setting by pressing the YES or NO
button.
• Select a list element by pressing the buttons LEFT or
RIGHT button.
• You always need to confirm by pressing the START but-
ton.
• Each time you add or insert a new step, default values have
been pre-programmed. So with less effort, complete programs
can be programmed. Refer to Basic Description of Controls
for a general explanation concerning the creation of wash pro-
grams.
• You can recognize a list element by the buttons LEFT and
RIGHT symbol at the right side on the display.
• The arrow down symbol on the display points to the last
Menu Item : EXIT.
Selecting the Wash Part
CFD1356R_SVG
Z
Type: Prewash
Prewash
Spin
Figure 21
• If you have selected Add Step, Edit Step or Insert Step, you
have to select the wash sequence now.
• Depending on the machine type, with top or front soap dis-
penser, you have more or less sequences available.
• Prewash
Programming
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
50 Part No. D1676ENR11