Toolbox Menu
Display Message Information
Imbalance Statistics …
Imbalance …
1 ...0.5 0
...
31 > 15 0
Current …
1 I0 0
...
4 I3 0
Diagnostic information on imbalance of the machine.
Inverter Power Off By this function it‘s possible to switch on the power of the inverter if a tech-
nical intervention is needed.
NOTE: Special care has been taken at the initialization of the pa-
rameters of the frequency inverter. The manufacturer is not re-
sponsible for the wrong behavior of the washing machine if the
owner has installed new parameter settings in the inverter that
do not correspond with the original settings at the factory.
Reset Service Counts No Once the washing machine has reached the total number of wash cycles like
set at the "Service Interval" a warning is given at the end of each cycle until
the Cycle Counter has been reset.
RTC Time XX:YY:ZZ The Time value of the Real Time Clock.
XX : Hours, YY : Minutes, ZZ : Seconds
RTC Date AA:BB:CC The Date value of the Real Time Clock.
AA : Day, BB : Month, CC : Year
Adjust Clock …
Hour XX
Minutes YY
Day AA
Month BB
Year CC
Set the correct Date and Time for the RTC.
Exit Return to Service Menu
Table 55
Diagnostic Program
The purpose of the diagnostic program is to test the wash ma-
chine functions one by one.
How to Get into the Diagnostic Menu
The Diagnostic menu can only be accessed when the machine is
in standby (the power is switched on, but no program is started).
• The program overview is shown.
Troubleshooting
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
87 Part No. D1676ENR11
To Next Page
Loading...
