Failure Message Overview
Num-
ber
Failure Mes-
sage Failure Action Fault Occurrence
E44 Model Type Incorrect selection of machine
type
Make correct selection Configuration menu
E45 Speed sensor The drum rotation sensor is not
working
Full stop + tumble Before spin sequence
E60 Inner Door Lock Not locked inner door Full stop Whole cycle
E77 Heating Time Out Heating on Hold Signal Failure Full stop + tumble Wash step
E80 SoapTimeOut On Hold Signal Failure Soap
Dispensing System
Full stop + tumble Whole cycle
E106 Calibration Error Weighing system calibration er-
ror
The Ultrabalance weighing sys-
tem was not calibrated before
the first use
The Ultrabalance weighing sys-
tem cannot be used
E107 Not Calibrated The Ultrabalance weighing sys-
tem was not calibrated before
the first use
The Ultrabalance weighing sys-
tem cannot be used
Before start
E300-
E353
Mits Err Specific Mitsubishi Inverter
Alarm
Full stop + safety time Whole cycle
E500-
E526
Memory Err Memory Error Full stop + safety time Any time
E560-
E563
USB Errors Errors in communication with
USB flash disk
For Informatoion only Only in Advanced menu Data
Export/Import
E570-
E571
Enh.Debit Problem with card reader pay-
ment system
For Informatoion only Whole cycle
E600-
E628
Softw. Err Software Error Full stop + safety time Any time
Table 53
Service Menu
In the Service menu you have some extra utilities:
• The Software Version Number.
• An overview of the 20 last failure messages.
• Statistics for 10 general error messages.
• An overview of the input states.
• Switching On the Inverter for a technical intervention.
• Reset Cycle Counter and Statistics Error Messages.
How to Get into the Service Menu
Figure 30
The SERVICE menu can only be accessed when the machine is
in standby (the power is switched on, but no program is started).
• The program overview is shown.
Troubleshooting
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
84 Part No. D1676ENR11
To Next Page
Loading...
