The Spray Sequence
Display Mes-
sage Default Information Limits
RPM - The suggested RPM depends on the machine Type. Refer to Table 7
Drain Valve 1 Only available on washing machines with both : a normal Open and
normal Closed Drain valve.
1 - 2
Detergents
Menu…
Supply 1, …, 8
0 seconds Time selection for Soap Boxes (hopper) and external liquid soap sup-
plies.
The Spray sequence only functions with 1 Supply. If you have pro-
grammed more then 1 supply an error message will be generated. Put
the time of the supplies back to zero until not more than 1 non-zero
time value is remaining.
If No supply has been programmed: the Spray sequence will be skip-
ped.
(Liquid soap supplies must be switched on at the configuration
menu).
0 - 99 seconds
Pause No When a signal Pause is programmed, a pause will be introduced at the
end of the Wash Step. This allows the operator to add soap for the next
step. A buzzer signal warns the operator that the cycle has been inter-
rupted.
No / Yes
Table 31
The No Wash Sequence
• Prewash
• Wash
• Cooldown
• Rinse
• Extra Rinse
• Final Rinse
• Soak
• Spray
• No wash
In case of a No Wash Sequence, the wash function of the pro-
grammed step is skipped. Go to Step 5: Programming the Drain
Step.
Step 5: Programming the Drain Step
This paragraph gives a detailed explanation about program-
ming the Drain/Extraction Sequences.
After programming the wash step, the drain/extraction step still
has to be programmed.
NOTE: You don’t have to program a drain sequence be-
fore an extraction sequence as the water will automati-
cally be drained at the extraction sequence.
Selecting the Drain / Extraction Step
Depending on the machine type, you have more or less functions.
CFD1357R_SVG
Z
Type: Drain
Wash
Drain
Figure 22
• For a new step, the first sequence that is displayed is the
Drain sequence (default).
• Select the desired Drain step sequence from the list by press-
ing the buttons LEFT or RIGHT .
• Press the ENTER button to confirm your selection.
• You can also use the ARROW DOWN button if you accept
the pre-programmed default value.
Programming
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
59 Part No. D1676ENR11
To Next Page
Loading...
