The Extra Rinse Sequence
Display Mes-
sage Default Information Limits
Inlet I1-I2-I7 3 Inlets can be programmed.
The suggested inlet valves are related to the temperature and the soap
box to be used.
NOTE: If you insert other inlet valves than the suggested
ones, problems can occur at the water fill process.
I1,2,3,4,7
Level Normal High The suggested water level depends on the machine Type. Refer to Table 6
RPM - The suggested RPM depends on the machine Type. Refer to Table 7
Detergents
Menu…
Supply 1, …, 8
0 seconds Time selection for Soap Boxes (hopper) and external liquid soap sup-
plies.
You can program up to 4 supplies at the same time. If you have pro-
grammed more then 4 supplies an error message will be generated.
Put the time of the supplies back to zero until not more than 4 non-
zero time values are remaining.
(liquid soap supplies must be switched on at the configuration menu) .
0 - 99 seconds
On Time 12 seconds The wash action (motor "On" Time).
Gentle wash action : 3 seconds.
(The suggested default values can be adjusted at the Initialization
menu)
1 - 99 seconds
Off Time 3 seconds The wash action (motor "Off" Time). Gentle wash action : 12 sec-
onds. (The suggested default values can be adjusted at the Initializa-
tion menu)
1 - 99 seconds
Time 2.0 minutes The Rinse Sequence Time.
(for 0 Minutes the Rinse sequence will be skipped) (programmable in
steps of 0.5 Minutes)
0 - 99.5 minutes
Pause No When a signal Pause is programmed, a pause will be introduced at the
end of the Wash Step. This allows the operator to add soap for the next
step. A buzzer signal warns the operator that the cycle has been inter-
rupted.
No / Yes
Table 28
The Final Rinse Sequence
• Prewash
• Wash
• Cooldown
• Rinse
• Extra Rinse
• Final Rinse
• Soak
• Spray
• No wash
• No temperature can be programmed as a Last Rinse is only
dedicated for cold (hard) water.
Programming
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
56 Part No. D1676ENR11
To Next Page
Loading...
