The Final Rinse Sequence
Display Mes-
sage Default Information Limits
Inlet I4-I7
(3 inlets)
I4
(2 inlets)
3 Inlets can be programmed.
The suggested inlet valves are related to the temperature and the soap
box to be used.
NOTE: If you insert other inlet valves than the suggested
ones, problems can occur at the water fill process.
I1,2,3,4,7
Level Normal High The suggested water level depends on the machine Type. Refer to Table 6
RPM - The suggested RPM depends on the machine Type. Refer to Table 7
Detergents
Menu…
Supply 1, …, 8
0 seconds Time selection for external liquid soap supplies. You can program up
to 4 supplies at the same time. If you have programmed more then 4
supplies an error message will be generated. Put the time of the sup-
plies back to zero until not more than 4 non-zero time values are re-
maining.
(liquid soap supplies must be switched on at the configuration menu) .
0 - 99 seconds
On Time 12 seconds The wash action (motor "On" Time).
Gentle wash action : 3 seconds.
(The suggested default values can be adjusted at the Initialization
menu)
1 - 99 seconds
Off Time 3 seconds The wash action (motor "Off" Time).
Gentle wash action : 12 seconds.
(The suggested default values can be adjusted at the Initialization
menu)
1 - 99 seconds
Time 2.0 minutes The Final Rinse Sequence Time.
(for 0 Minutes the Final Rinse sequence will be skipped) (program-
mable in steps of 0.5 Minutes)
0 - 99.5 minutes
Pause No When a signal Pause is programmed, a pause will be introduced at the
end of the Wash Step. This allows the operator to add soap for the next
step. A buzzer signal warns the operator that the cycle has been inter-
rupted.
No / Yes
Table 29
The Soak Sequence
• Prewash
• Wash
• Cooldown
• Rinse
• Extra Rinse
• Final Rinse
• Soak
• Spray
• No wash
Programming
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
57 Part No. D1676ENR11
To Next Page
Loading...
