Test Sequence
• Display test and door lock test
• Sensor test
• Motor test
• Water fill, heating and drain test
• BASIC Diagnostic Wash program
Diagnostic Test Sequence
Test Information Explanation
1 Black display followed by a Text
display.
Door lock test (locks and unlocks 5 x the door)
Display test
** None Sensor test (all wash machine sensors are tested)
3 Motor Reverse Wash speed (inverse direction high spin)
4 Motor Stop Standstill motor
5 Motor Forward Wash speed (same direction high spin)
6 Motor Distribute Distribution speed (same direction high spin)
7 Motor Low spin Low spin speed (same direction high spin)
8 Motor High spin High spin speed
9 Motor Stop Free run or controlled deceleration
20 Inlet I1 The machine takes water by inlet 1
21 Drain 1 The water is drained by drain valve 1
22 Inlet I2 The machine takes water by inlet 2 until the safety level for heating is
reached
Heating activated (only if Wait temp = on)
23 Drain 1 (2)* The water is drained by drain valve 1
24 Inlet I3 The machine takes water by inlet 3
25 Drain 1 The water is drained by drain valve 1
26 Inlet I4 The machine takes water by inlet 4
27 Drain 1 The water is drained by drain valve 1
28 Inlet I5 The machine takes water by inlet 5
29 Drain 1 The water is drained by drain valve 1
30 Inlet I6 The machine takes water by inlet 6
31 Drain 1 The water is drained by drain valve 1
32 Inlet I7 The machine takes water by inlet 7
33 Drain 1 The water is drained by drain valve 1
34 Inlet I8 The machine takes water by inlet 8
35 Drain 1 The water is drained by drain valve 1
50 Tumble The tumble sequence
Table 56 continues...
Troubleshooting
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
89 Part No. D1676ENR11
To Next Page
Loading...
