Available Wash Sequences
Available Wash Sequences: Prewash, Wash, Cooldown, Rinse,
Extra Rinse, Final Rinse, Soak, Spray, No Wash.
Available drain/extraction sequences: Drain, Extract, No drain,
Static drain, Rev drain.
The Creation of a Wash Program
• A Wash Program is created step by step.
• Each step always consists of a Wash sequence and a
Drain/Extraction sequence.
Programming the Wash Sequence
First choose the type of Wash sequence.
• PREWASH
• WASH
• COOLDOWN
• RINSE
• EXTRA RINSE
• FINAL RINSE
• SOAK
• SPRAY
• No WASH
Then program all the related functions of the sequence.
Available functions
• Temperature
• Water Level
• Water Inlet Valves
• The Wash Speed
• The Reversing Interval times
• Supplies
• Sequence Time (length of step)
• Drain valve 1 - 2
• Pause Signal
Each step is pre-loaded with default settings. When creating a
program, you can choose to utilize these suggested settings.
Programming the Drain Sequence
After programming the Wash sequence, next program the Drain/
Extraction sequence.
• DRAIN
• EXTRACTION
• No DRAIN
• STATIC DRAIN
• REVERSING DRAIN
Then program all the related functions of the Drain/Extraction se-
quence.
Available functions
• Sequence Time (length of step)
• Speed
• Drain valve 1 - 2
You can skip a sequence between two by programming No
WASH or No Drain.
Example : The No drain sequence should be programmed be-
tween a wash and a cooldown sequence.
NOTE: A more detailed explanation for the specific se-
quences can be found in Chapter Step 4: Programming
the Wash Part , Step 5: Programming the Drain Step.
The Tumble Sequence
• The wash cycle will always end with the Tumble sequence.
• The tumble sequence takes 30 Seconds, then the program is
finished and the door can be opened.
• The Tumble sequence cannot be skipped.
Programming the Functions
Limits
• To ensure the correct functionality of the washing machine
you have to program values within certain limits.
• If you program a value that falls below the minimal or above
the maximal programmable limit then the new value will not
be accepted and the previous value stays valid.
Programming the Water Temperature
Limits
• Minimum value : 33.8°F [1°C]
• Maximum value : 113°F [45°C] for the PREWASH and
SOAK and 197.6°F [92°C] for the WASH sequence.
• For RINSE, EXTRA RINSE, FINAL RINSE and SPRAY no
Temperature can be programmed.
Programming the Water Inlets Valves
• Depending on the programmed temperature the water inlet
valves are suggested.
• While the tub is filling with water, the computer controls the
water temperature. By switching on and off the hot and cold
water inlet valves the correct water temperature is obtained.
• For machines with a Top Soap Dispenser you have to consider
that by programming the water inlet valves, at the same time,
you are also selecting the soap Box at which the soap must be
added.
• If you want to program a wash sequence with :
• Cold Water : only Cold Inlet Valves must be programmed
• Warm or Hot water : Cold and Hot Inlet Valves must be
programmed
Top Soap Dispenser Machines
The Cold Water Inlet Valves
Basic Description of Controls
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
16 Part No. D1676ENR11
To Next Page
Loading...
