• Inlet Valve 1 corresponds with soap box for a Prewash.
• Inlet Valve 2 corresponds with soap box for a Wash - deter-
gent.
• Inlet Valve 3 corresponds with soap box for a Wash - liquid
soap.
• Inlet Valve 4 corresponds with soap box for a Final Rinse.
• Inlet Valve 7 is a direct Inlet Valve and speeds up the water
fill process.
The Hot Water Inlet Valves
• Inlet Valve 5 corresponds with soap box for a Prewash.
• Inlet Valve 6 corresponds with soap box for a Wash - deter-
gent.
• Inlet Valve 8 corresponds with soap box for a Wash - liquid
soap.
How to Select Inlet Valves: EXAMPLE
For a Prewash: Programmable tem-
perature:
33.8 - 113°F [1 -
45°C]
Inlet Valve 1 (cold)
and/or 5 (hot)
soap box for a Pre-
wash
and/or 7 (cold) direct Inlets
For a Wash: Programmable tem-
perature:
33.8 - 197.6°F [1 -
92°C]
Inlet Valve 2 (cold)
and/or 6 (hot)
soap box for a
Wash - detergent
and/or 7 (cold) direct Inlets
For a Rinse: Inlet valves 1+2+7
(cold)
No detergent is
added
Table 3 continues...
How to Select Inlet Valves: EXAMPLE
For a Final Rinse: Inlet valve 4 soap box for a Final
rinse
and/or 7 (cold) direct inlets
Table 3
WARNING
For machines with liquid supply pumps, direct water
inlet valve 7 must be programmed because the liquid
is added at the direct water inlet channel. For wash-
ing machines with water recycling, the water recy-
cling supply must be connected to inlet valve 5 or 7.
C015
Programming the Water Level
Water Level Limits
• Refer to Table 6 . The values are different for each machine
type.
• Minimum value: above the heating elements and the tempera-
ture sensor.
• Maximum value: half the wash drum.
Normal Low Level, Normal High Level
• The Normal Low Level is recommended for the PREWASH,
WASH and SOAK sequences.
• The Normal High Level is recommended for the RINSE and
FINAL RINSE Sequences.
• At the COOLDOWN sequence, the Wash Computer makes
use of a low water level and is draining the water automatical-
ly.
• At the Spray sequence, the Drain valve stays open.
Wet Cleaning Selection Configuration Menu
• It’s possible to program a level below default minimum pro-
grammable level. Refer to Table 6 .
• The heating will not be functional for a water level below the
standard minimum programmable water level.
NOTE: For woolens and other delicate linen a normal
high water level is recommended. The economic func-
tion should only be used for lightly soiled and/or small-
er volumes of laundry. In other cases, the program will
give poor washing quality.
Basic Description of Controls
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
17 Part No. D1676ENR11
To Next Page
Loading...
