The Cooldown Sequence
Display Mes-
sage Default Information Limits
On Time 12 seconds The wash action (motor "On" Time). Gentle wash action : 3 seconds.
(The suggested default values can be adjusted at the Initialization
menu)
1 - 99 seconds
Off Time 3 seconds The wash action (motor "Off" Time). Gentle wash action : 12 sec-
onds.
(The suggested default values can be adjusted at the Initialization
menu)
1 - 99 seconds
Time 7.0 minutes The programmed time = time needed to decrease the water tempera-
ture.
Once the programmed temperature has been reached, the next Se-
quence will be started.
(for 0 Minutes the Prewash sequence will be skipped) (programmable
in steps of 0.5 Minutes)
NOTE: If a short time is programmed, the water temperature
will decrease fast.
NOTE: Recommendation! Program 1 minute for each 37.4 °F
[3 °C] temperature drop. Example : For a hot wash of 194 °F
[90 °C] and a Cooldown Sequence of 140 °F [60 °C] a time of
about 86 °F/37.4 °F [30 °C/3 °C] = 10 Minutes should be pro-
grammed for the Cooldown Sequence.
0 - 99.5 minutes
Pause No When a signal Pause is programmed, a pause will be introduced at the
end of the Wash Step. This allows the operator to add soap for the next
step. A buzzer signal warns the operator that the cycle has been inter-
rupted.
No / Yes
Table 26
The Rinse Sequence
• Prewash
• Wash
• Cooldown
• Rinse
• Extra Rinse
• Final Rinse
• Soak
• Spray
• No wash
• No temperature can be programmed as a Rinse is only dedi-
cated for cold water.
Programming
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
54 Part No. D1676ENR11
To Next Page
Loading...
