The Prewash Sequence
Display Mes-
sage Default Information Limits
Pause No When a signal Pause is programmed, a pause will be introduced at the
end of the Wash Step. This allows the operator to add soap for the next
step. A buzzer signal warns the operator that the cycle has been inter-
rupted.
No / Yes
Table 24
The Wash Sequence
• Prewash
• Wash
• Cooldown
• Rinse
• Extra Rinse
• Final Rinse
• Soak
• Spray
• No wash
The Wash Sequence
Display Mes-
sage Default Information Limits
Temperature 140°F [60°C] The water temperature. 33.8 - 197.6°F [1
- 92°C]
Inlet I1-I2-I3-I5-
I6-I8
The suggested inlet valves are related to the temperature and the soap
box to be used.
NOTE: If you insert other inlet valves than the suggested
ones, problems can occur at the water fill process.
I1...I8
Level Normal Low The suggested water level depends on the machine Type. Refer to Table 6
RPM - The suggested RPM depends on the machine Type. Refer to Table 7
Detergents
Menu…
Supply 1, …, 8
0 seconds Time selection for Soap Boxes (hopper) and external liquid soap sup-
plies.
You can program up to 4 supplies at the same time. If you have pro-
grammed more then 4 supplies an error message will be generated.
Put the time of the supplies back to zero until not more than 4 non-
zero time values are remaining.
(Liquid Soap Supplies Must Be Switched On At The Configuration
Menu)
0 - 99 seconds
On Time 12 seconds The wash action (motor "On" Time). Gentle wash action : 3 seconds.
(The suggested default values can be adjusted at the Initialization
menu)
1 - 99 seconds
Table 25 continues...
Programming
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
52 Part No. D1676ENR11
To Next Page
Loading...
