Initializing the Machine
Initializing the Machine Goes in Four Steps:
1. Install the machine mechanically. Refer to Installation/Opera-
tion/Maintenance Manual.
2. Select the machine specific settings in the Configuration
Menu.
3. Select the operator specific settings in the Initialization Menu.
4. Adjust standard Programs or create new Programs at the Pro-
gram Menu.
WARNING
The initialization should be performed by qualified
personnel only. An incorrect initialization may cause
serious injuries and serious damage to the machine!
C026
WARNING
Before making changes in the configuration and ini-
tialization menu read this manual carefully.
C027
Changes you have made will influence the wash program proc-
esses.
We recommend before making changes to carefully write down
what the previous settings were.
As the wash computer is used for a whole range of washing ma-
chines, after the installation of a new wash computer, you need to
program machine specific settings into the configuration menu.
At the installation of new software, after loading the factory set-
tings you need to check the default settings one by one to find out
if they correspond with the setup as you prefer.
The configuration and initialization of the washing machine has
been done at the factory. For the creation of new programs, no
changes have to be made in the initialization or configuration me-
nus.
Initialization Menu
How to Get into the Initialization Menu
The initialization menu can only be accessed when the machine is
in standby (the power is switched on, but no program is started).
• The program overview is shown.
NORMAL
HOT
$7.00
NORMAL WARM $6.50
NORMAL COLD $6
.
00
EXTRA WASH HOT $7.50
CHM1686R1
1
2
3
4
Figure 7
• Switch the machine to the setup mode. Refer to section How
to Get into the Setup Mode.
• The Main menu is now available.
• The Initialization Menu is the first Menu.
Figure 8
• Press the START button to make your selection.
• Now you will see the first menu item.
• By pressing the ARROW DOWN or UP button you can select
the menu items one by one.
Initialization Menu
Display Mes-
sage Default Information Limits
Language English Language selection: English, Spanish, French,… List
Table 8 continues...
Initializing the Machine
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
27 Part No. D1676ENR11
To Next Page
Loading...
