Speed of Machines with Frequency Inverter
Machine Type
Wash Speed Spin Speed
Low
Spin
Speed
Default
RPM
Mini-
mum
RPM
Maxi-
mum
RPM
Default
RPM
Mini-
mum
RPM
Lock-
ing
RPM
Maxi-
mum
RPM
Default
RPM
35 kg / 80 lb / 332 L (G-
factor 100)
38 10 55 390 150 91-149 440 250
35 kg / 80 lb / 332 L (G-
factor 150)
38 10 55 490 150 91-149 540 250
Table 7
Programming the Wash Speed
• Standard reversing wash speed is between 40 and 50 RPM.
Exact values can be found in Table 7 .
• For some special applications the drum should only turn very
slowly.
Speed Limits
• The minimum programmable wash speed is 10 RPM.
• The maximum programmable wash speed is 40 - 60 RPM, de-
pending on machine size.
Programming Extraction Speed
Extraction [150 - 1165] RPM
• An Intermediate spin between two sequences should be about
½ of the max spin.
• Between 90 and 150 RPM . Refer to Table 7 to verify exact
value. It’s not allowed to program a steady speed, as the ma-
chine could VIBRATE TOO MUCH.
Speed Limits
• Refer to Table 7 which contains the minimum and maximum
speed limits. The limits differ depending on the maximum al-
lowed g-force at high spin for each washing machine type.
Programming Supplies
• Up to 4 Supplies can be programmed at the same time in a se-
quence.
• If Liquid soap pumps have been installed on the washing ma-
chine, then these pumps will be activated by programming a
time value for the corresponding supply signal 1, 2, 3, 4, 5, 6,
7, 8.
Time Limits
• The maximum programmable time is 99 Seconds.
• If the time is 0 Seconds then the supply will NOT be activated
at the wash process.
NOTE: If for some special application more than 4
supplies must be programmed in the same se-
quence, this can be solved by programming the
same sequence twice; one after the other. Split the
water level (so it will take water for the second fill,
say 60%, 100%), step time, and the number of sup-
plies, over the two subsequent sequences. Program
A "NO DRAIN" between the two sequences to avoid
draining the water. Set temperature the same for
both parts.
Programming the Motor On and Off Times for
Reversing
• The standard Reversing Motor On and Off times at Wash
speed is 12 seconds On and 3 seconds Off.
• For Delicates and Woolens it’s recommended to program a
gentle wash action with a Reversing On time of 3 seconds and
an Off time of 12 seconds.
Programming the Sequence Time
• The sequence time starts running after the water level is
reached.
• If wait for Temperature has been selected, the sequence time
starts running only once the programmed temperature has
been reached at the heating process.
• For a Cooldown Sequence, the programmed time corresponds
with the time for decreasing the water temperature.
Recommendation:
At least a cooldown of 3 minutes must be programmed. And to
avoid the shrinking of the garments, it’s recommended to pro-
gram the time so that the temperature will decrease with about
37.4°F [3°C] for each minute.
Basic Description of Controls
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
25 Part No. D1676ENR11
To Next Page
Loading...
