The Wash Sequence
Display Mes-
sage Default Information Limits
Off Time 3 seconds The wash action (motor "Off" Time). Gentle wash action : 12 sec-
onds.
(The suggested default values can be adjusted at the Initialization
menu)
1 - 99 seconds
Time 7.0 minutes The Wash Sequence Time.
(for 0 Minutes the Wash sequence will be skipped) (programmable in
steps of 0.5 Minutes)
0 - 99.5 minutes
Pause No When a signal Pause is programmed, a pause will be introduced at the
end of the Wash Step. This allows the operator to add soap for the next
step. A buzzer signal warns the operator that the cycle has been inter-
rupted.
No / Yes
Table 25
The Cooldown Sequence
• Prewash
• Wash
• Cooldown
• Rinse
• Extra Rinse
• Final Rinse
• Soak
• Spray
• No wash
• After a Hot wash you can program a Cooldown Sequence to
avoid temperature shock and shrinking of the garments.
• The drain step after the Hot wash must be put on NO DRAIN.
• No inlets are programmable :
• machine with three water inlets: inlet 7 is the standard in-
let.
• machine with two water inlets: inlet 1 is the standard inlet.
• The water level can‘t be programmed as the process of adding
and draining water doesn’t allow this.
WARNING
Do not program a drain sequence before a cooldown
sequence.
C048
The Cooldown Sequence
Display Mes-
sage Default Information Limits
Temperature 140 °F [60 °C] The water temperature. 33.8 - 140 °F [1 -
60 °C]
RPM - The suggested RPM depends on the machine Type. Refer to Table 7
Drain Valve 1 Only available on washing machines with both : a normal Open and
normal Closed Drain valve.
1 - 2
Table 26 continues...
Programming
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
53 Part No. D1676ENR11
To Next Page
Loading...
