Initialization Menu
Display Mes-
sage Default Information Limits
Direct selection 2 0 Direct selection 2 is a pre-set program which will start operating when
the RIGHT button is pressed. The 0 value means there is no pre-set
program.
0..15
Eco mode 0 min Setting of a time limit upon expiration of which the control electronics
switch into an energy saving mode. 0 value means that the Energy Sav-
ing Mode is disabled.
0..99
Lock Pretest Limit 0 Setting of number of attempts for correct door closing before the pro-
gram is started. If the number of attempts is exceeded, a warning mes-
sage is generated. If set to 0, the test sequence of correct door closing
will be skipped.
0 - 10
Safety Stop No When enabled, during washing machine can be stopped by pressing
and holding "F" key.
No / Yes
Average Cycle Time No When enabled, the displayed cycle time is the average of the last 4 cy-
cle times. This will be displayed next to the asterisk symbol (*).
When disabled, the calculated washing cycle time will be displayed.
No / Yes
Exit Return to Main Menu
(*) Automatic Cooldown
To avoid mechanical temperature shock and to extend the life time of your washing machine, after a hot wash, cold water is tem-
perature will be lowered to about 149°F [65°C] .
The automatic cooldown function will only be functional if a hot wash with a temperature above 149°F [65°C] has been program-
med and if a cold water inlet valve is programmed in the next step. When a Cooldown sequence has been programmed, the auto-
matic cooldown will not function.
The automatic cooldown differs from a normal cooldown sequence. The purpose of a normal cooldown sequence is to avoid the
shrinking of the garments. (Takes more time). Refer to section Programming.
Table 8
Configuration Menu
This electronic wash computer has been specially constructed for
a wide range of washing machines. For that reason it must be in-
dividually set up with important parameters for various machine
types. Basic machine adjusting is made in the factory.
WARNING
Only a qualified technician should change the con-
figuration set up. An incorrect configuration can
cause injuries and serious machine damage.
C028
How to Get into the Configuration Menu
The configuration menu can only be accessed when the machine
is in standby (the power is switched on, but no program is start-
ed).
• The program overview is shown.
• Switch the machine to the setup mode. Refer to section How
to Get into the Setup Mode.
• The Main Menu is now available.
• Press the ARROW DOWN button to select the Configuration
Menu.
Initializing the Machine
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
31 Part No. D1676ENR11
To Next Page
Loading...
