EasyManua.ls Logo

Alliance Laundry Systems PA20 X CONTROL - Page 30

Alliance Laundry Systems PA20 X CONTROL
110 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Initialization Menu
Display Mes-
sage Default Information Limits
External Wait Con-
trol
Off Liquid soap supply system:
Slection for a washing machine connected to a central liquid soap
supply system.
Some washing machines are connected to a central liquid soap supply
system which can only provide 1 washing machine at a time with liq-
uid soap.
This central pump system is able to let Wait the washing machine be-
fore continuing the wash process until the central pump system is free
to pump the liquid soap supply into the machine.
Heating, (for installations with limited power supply):
You can disable the heating system of the machine by an external sig-
nal.
The heating will switch on again and the wash process will continue
as soon as the external signal is switched off.
Wait:
External signal suspends the whole wash process until the external
signal gets switched off.
Time:
External signal stops the count-down of washing process. All func-
tions of wash cycle continue. When the external signal stops, the
count-down will continue in a standard manner.
No / Soap / Heat-
ing / Wait Time
Extra Soap Timing 0 Seconds (Off) When enabled, this feature allows the soap dispenser valves to open in-
dividually for the programmed time.
0 - 20 Seconds
Prewash Soap Info Yes Selection whether the information on soap dosage for prewash should
be shown or not.
No / Yes
Wash Liquid Soap
Info
Yes Selection whether the information on liquid soap dosage for the main
wash should be shown or not.
No / Yes
Temp. info Yes Selection whether the temperature information of selected program
should be displayed
No / Yes
Preset Program 0 Entering the number of pre-set program. After the wash cycle has fin-
ished and the door has been opened, the program selection will be set
to the pre-set program. The value "0" means there is no pre-set pro-
gram.
0..15
Direct selection 1 0 Direct selection 1 is a pre-set program which will start operating when
the LEFT button is pressed. The 0 value means there is no pre-set pro-
gram.
0..15
Table 8  continues...
Initializing the Machine
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
30 Part No. D1676ENR11

Table of Contents

Other manuals for Alliance Laundry Systems PA20 X CONTROL

Related product manuals