EasyManua.ls Logo

Alliance Laundry Systems PA20 X CONTROL - Page 83

Alliance Laundry Systems PA20 X CONTROL
110 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Failure Message Overview
Num-
ber
Failure Mes-
sage Failure Action Fault Occurrence
E10 Temp. Not Reached Target temp. not reachet Full stop + tumble Wash step
E11 No Fill Fill failure Full stop + request for Contin-
ue
While filling
E12 OverFill Overfill failure Full stop + tumble While filling
E13 No Heating Heating failure Full stop + tumble While heating
E14 Heat. Time Heating time failure Full stop + request for continue While heating
E15 Too Hot Too Hot Full stop + tumble While heating
E16 Coin blocking 1 Coin meter failure / Before start up
E17 Coin blocking 2 Coin meter failure / Before start up
E18 Door Lock Pre-test Door check before start failure Don´t start Before start up
E19 Door Lock Start Door check at start failure Don´t start At start up
E21 OverFlow Overflow failure Full stop + tumble Wash step
E24 Level Sens Defective level sensor Continue + Don’t start Before start up
E25 Temp Sensor Defective temperature sensor Continue + Don’t start Before start up
E26 Mitsub. Code Undefined frequency inverter
error code
Full stop + tumble Whole cycle
E27 Comm fault Communication fault inverter Full stop + safety time Whole cycle
E28 THT time / E.OL THT Time out / E.OL Full stop + safety time At spin sequence
E29 OV3 time / E.OP OV3 Time out / E.OP Full stop + safety time At spin sequence
E31 Load Par Initialization fault inverter Don’t start At initialization
E32 Verify Par Verification fault inverter Don’t start At loading parameters
E35 Wrong Softw Wrong software version Don’t start New software version
E36 Imbalance Safety Switch activated. Reduction of spinning se-
quence revolutions. For Infor-
mation only.
Spinning sequence
E37 No Drain Spr Drain failure at the Spray Se-
quence
Full stop + tumble Spray Sequence
E39 Out of Soap The Soap Supplies are running
Out of Soap
For Information only Wash step
E41 Service Due Service Due Warning For Information only Open
door = reset
End cycle
E42 Connection No Network Connection For Information only Data Transfer Networking
E43 Voltage Par Wrong Voltage Range Selection Make correct selection Configuration menu
Table 53  continues...
Troubleshooting
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
83 Part No. D1676ENR11

Table of Contents

Other manuals for Alliance Laundry Systems PA20 X CONTROL

Related product manuals