Allied Telesis AT-8000S Series User Manual

Page 154
Allied Telesis AT-8000S Switch
Web Browser Interface User’s Guide
• Frame Check Sequence (FCS) Errors — Displays the number of FCS errors received on the selected
interface.
• Single Collision Frames — Displays the number of single collision frames received on the selected
interface.
• Late Collisions — Displays the number of late collision frames received on the selected interface.
• Excessive Collisions — Displays the number of excessive collisions received on the selected interface.
• Oversize Packets — Displays the number of oversized packet errors on the selected interface.
• Internal MAC Receive Errors — Displays the number of internal MAC received errors on the selected
interface.
• Received Pause Frames — Displays the number of received paused frames on the selected interface.
• Transmitted Paused Frames — Displays the number of paused frames transmitted from the selected
interface.
2. Select the Interface and the Refresh Rate. The selected interface’s Etherlike statistics are displayed.
To update the refresh time:
• To change the refresh rate for statistics, select another rate from the Refresh Rate dropdown list.
To reset Etherlike interface statistics counters:
1. Open the Etherlike Statistics Page.
2. Click Clear All Counters. The Etherlike interface statistics counters are cleared.

Allied Telesis AT-8000S Series Specifications

General

Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Humidity	5% to 95% non-condensing
Switching Capacity	104 Gbps
Forwarding Rate	77.4 Mpps
VLANs	4, 094
Layer 3 Features	Static routing, RIP v1/v2
Management	Web-based
Operating Humidity	10% to 90% non-condensing