4-6 | Model 933S UV Analyzer
Closing the Congurator Software
After you are finished communicating with the analyzer, close the Con-
figurator Software and disconnect the computer from the analyzer:
1. From the 93XS Properties dialog box, click OK or Cancel at the bottom
of the screen.
2. From the AMETEK Configurator window, select File\Exit.
3. Power down the computer and disconnect the serial cable from the
analyzer’s Communications Port.
4. Close the Communications Port cover and hand-tighten the screw to
secure it in place.
To Next Page
Loading...
Need help?
General
