Specications | 2-19
Certificate: 1031027
Project: 70097231
Master Contract: 164369
Date Issued: 2017-02-24
DQD 507 Rev. 2016-02-18 Page 3
The products listed are eligible to bear the CSA Mark shown with adjacent indicators 'C' and 'US' for Canada and
US (indicating that products have been manufactured to the requirements of both Canadian and U.S. Standards) or
with adjacent indicator 'US' for US only or without either indicator for Canada only.
(1) Submittor's name, trademark, or (the CSA file number adjacent the CSA Mark - optional).
(2) Catalogue / Model designation or equivalent.
(3) Complete electrical rating (amps, hertz, and volts).
(4) Applicable Hazardous Locations Class, Group and Division for Canada and the USA
(5) Temperature Code.
(6) Operating Temperature Range
(7) Date code / Serial number traceable to month and year of manufacture.
(8) The CSA Mark with “NRTL/C” or “C US” indicator adjacent.
(9) The IEC 417, No. 5032 Alternating Current symbol (manufacture may use this mark and refer to
accompanying documents);
(10) The ISO 3864, No. B.3.6 Caution, risk of electric shock symbol (refer to accompanying documents);
(11) The ISO 3864, No. B.3.1 Caution symbol (refer to accompanying documents);
(12) The ISO 417, No. 5041 Caution hot surface symbol (refer to accompanying documents) marked on the
and optional cell heater;
(13) The ISO 417, No. 5017 Earth (ground) symbol (refer to accompanying documents).
(14) Caution Warnings “OPEN CIRCUIT BEFORE REMOVING COVER”
And/or “OUVRIR LE CIRCUIT AVANT D’ENLEVER LE COUVERCLE”
(15) Caution Warnings “COVER JOINTS MUST BE CLEANED BEFORE REPLACING COVER”
And/or “NETTOYER LES SURFACES DE CONTACT DU COUVERCLE AVANT DE LE
REMETTRE EN PLACE”
(16a) Caution Warnings “FOR GAS GROUPS C &D and GROUP IIB A SEAL SHALL BE INSTALLED
WITHIN 450 MM OF THE ENCLOSURE”
And/or “UN SCELLEMENT DOIT ETRE INSTALLE A MOINS DE 450 MM DU BOITIER”
(16b) Caution Warnings “FOR GAS GROUPS B, C, & D and GROUP IIB+H2 A SEAL SHALL BE
INSTALLED WITHIN 10 inches OF THE ENCLOSURE”
And/or “UN SCELLEMENT DOIT ETRE INSTALLE A MOINS DE 254 MM DU BOITIER”
To Next Page
Loading...
Need help?
General
