Ametek 933S User Manual

Contents | v
S93XS System 200 Configurator Software Installation ............................................ 3-22
Minimum PC Requirements for Configurator Software .................................. 3-22
Installing the S93XS System 200 Configurator Software .................................. 3-23
Removing the Configurator Software ................................................................. 3-25
Start-Up and Verification ............................................................................................. 3-26
Powering Up the Analyzer .................................................................................... 3-26
Start-Up Diagnostic Checklist ...........................................................................3-36
Sample System Leak Check ......................................................................................... 3-38
Sample Conditioning System Optimization ............................................................. 3-41
Column Switch Time Optimization .................................................................... 3-41
Hold Time Optimization ....................................................................................... 3-46
CHAPTER 4 CONTROLLER / USER INTERFACE ............................................................. 4-1
System 200 Configurator Software Overview – Getting Started ............................ 4-2
Navigating in the Software ..................................................................................... 4-2
Starting the Configurator Software and Establishing Communication
Between the Analyzer and Computer .................................................................. 4-4
Closing the Configurator Software ........................................................................ 4-6
Configurator Software Troubleshooting ...............................................................4-7
General Tab ................................................................................................................ 4-9
Modbus Serial / Modbus TCP Communication Setup .......................................4-11
User Interface .......................................................................................................... 4-14
Setting Up the Main Window ............................................................................4-14
Viewing Device Activities ..................................................................................4-15
Saving Analyzer Configuration Parameters ......................................................4-16
Restoring Analyzer Configuration Parameters ..................................................4-16
Modifying Analyzer Device Settings ......................................................................... 4-18
Working From the Setup Tab ................................................................................ 4-18
Saving Analyzer Configuration Parameters to an ASCII File ...........................4-21
Printing Analyzer Configuration Parameters ....................................................4-21
Refreshing Configuration or Calibration Parameters ......................................... 4-22
Saving Configuration or Calibration Parameters to EEPROM .........................4-22
Optical Bench .....................................................................................................4-23
Cell/Miscellaneous (Compensations) Parameters ............................................... 4-28
Temperature Control ..........................................................................................4-31
Optical Bench Temperature Control ............................................................4-33
Measuring Cell (Oven) Temperature Control (Optional) ...........................4-34
Column Block Temperature Control ............................................................4-36
Output Setup .....................................................................................................4-37
Sensors Setup .....................................................................................................4-40
Modbus Settings .................................................................................................4-46
Matrix ................................................................................................................4-47
Analytical Parameters.........................................................................................4-48
Analog Inputs ..................................................................................................... 4-49
Setting Gas Calibration Parameters ...................................................................4-51

Ametek 933S Specifications

General

Brand	Ametek
Model	933S
Category	Measuring Instruments
Language	English