F1 Change language
The user can chose between two languages, German and English. The user can chose between two languages,
German and English.
F2 LCD - Backlighting
With the use of F2 the backlighting can be switched on or off.
Additionally the Auto Off function can be programmed to switch Off the backlighting after a defined time that the
equipment has not been in operation (1 - 30minBecause of the limited lifetime of LCD displays, approx. 10,000h
this function should always be activated.
F3 Interfaces
This menu will help the user to define the status of the integrated serial and parallel interfaces, e.g. the baud rate
of the RS 232 or the address of the IEEE interface.
F4 Beeper
In the beep menu F1 is the selector for switch ON / OFF the keyboard-beep. The test-finish-beep is not
selectable and sounds always 3 times when a test routine is finished.
F5 Operating time
Pressing of F5 will show the total operating time of the test equipment. There are two timers,
- Total operating time (powered on)
- Testing time (total testing time)
To Next Page
Loading...
Need help?
General
