Ametek OCS 500N6 Series - Technical Specifications and Data; Slow Damped Oscillatory Wave Specs (IEC 61000-4-18)

AMETEK CTS OCS 500 N6 series
Manual for Operation V 5.24 26 / 80
5.
Technical data
5.1.
Slow damped oscillatory as per IEC 61000-4-18
Test Level
Output voltage
250 V – 2`500 V  10 %
250 V – 3`000 V  10 % HV out on model N6.5; N6.6; N6.7; N6.8
Wave form (open circuit):
Rise time
75 ns  20 %
Oscillation frequency
100 kHz and 1 MHz  10 %
Decaying
Peak 5 must be > 50 % of peak 1 value
Peak 10 must be < 50 % of peak 1 value
No requirements for other peaks
Source impedance
Coupling capacitors
200   20 %
0,5 µF  10 %
Polarity
Positive, Negative
Repetition rate
At least 40/ s for 100 kHz and
At least 400/ s for 1 MHz
Trigger
Trigger of bursts
AUTO, MANUAL, EXTERN (min. repetition time 0.1 s)
Repetition rate, Rep
20/ s – 50/ s for 100 kHz
20/ s – 400/ s for 1 MHz
Burst duration td
0.1 s – 99.9 s
Burst repetition time tr
0.1 s – 99.9 s
Test duration T
0:01 min – 99:59 min  1 s, endless
Output
Direct at the front panel
2 banana plugs for:
- For connect ext. coupling devices with firmware V 3.30axx and higher
Ri = 100  for coupling set to “Ext CN”
Ri = 200  for coupling set to “\”
- For previous firmware versions up to V3.24a xy
Ri =200  for coupling set to “\”
coupling “ExtCN” not awailable
- Magnetic Field antenna 100 Am
-1
(Firmware Version 1.13 and higher)
- Magnetic Field antenna 60 Am
-1
(Firmware Version 1.10 up to 1.12)
Coupling network 1 phase
To L, N, PE all combinations
Coupling network 3 phase
L1...L3-N, L1...L3-PE, N-PE, L1+L2+L3-PE , L1+L2+L3+N-PE
EUT Supply
AC 250 V / 16 A / 50/60 Hz
DC 250 V/10 A