Angelo AT 61E - Page 84

- 38 -
3378702_ATE_ut_GB ENGLISH
GB
E10
Electrical component com-
partment has overheated.
The oven solves the problem
on its own.
The oven’s functions are ena-
bled so cooking cycles can be
carried out.
E11
E13
E14
Electronic circuit board diag-
nostics tripped.
Inform the after-sales service.
The oven’s functions are disa-
bled so no cooking cycles can
be carried out.
E15 ROI pre- lter expired.
Replace the ROI pre- lter as
soon as possible.
The oven’s functions are ena-
bled so cooking cycles can be
carried out.
E16 Osmosis membrane expired.
Replace the ROI osmosis mem-
brane as soon as possible.
The oven’s functions are ena-
bled so cooking cycles can be
carried out.
E19
The humidity probe has failed
or is not properly connected.
Inform the after-sales service
The oven’s functions are ena-
bled so cooking cycles can be
carried out.
E20 Setup error. Inform the after-sales service
The oven’s functions are disa-
bled so no cooking cycles can
be carried out.
E21
The washing cycle has been
interrupted because there is
no cleaner.
Check the pipe position and
the level of cleaner in the tank;
top up if necessary and restart
the washing cycle.
If the problem persists, call the
after-sales service.
E22
The washing cycle has been
interrupted because there is
no descaling cleaner.
Check the pipe position and
the level of descaling cleaner
in the tank; top up if necessary
and restart the washing cycle.
If the problem persists, call the
after-sales service.
E23
The washing cycle has been in-
terrupted during the  nal sani-
tization stage
Press the reset button and
rinse the cooking chamber
thoroughly by hand
If the problem persists, call the
after-sales service.
E24
E26
Automatic cleaning system
failure.
Check that no residues of
cleaning products have been
left inside the cooking cham-
ber.
If the problem persists, call the
after-sales service.
The oven’s functions are ena-
bled so cooking cycles can be
carried out.
E25
System  lling procedure not
completed.
Check the position of the pipe-
and the level of the descaling
inthe container; if necessary,
topit up and re-launch the au-
tomatic cleaning cycle.
If the problem persists, call the
after-sales service.
E29
Core probe not inserted in the
food.
Insert the core probe.
The oven’s functions are ena-
bled so cooking cycles can be
carried out.
E30 Faulty panel board. Inform the after-sales service
The oven’s functions are disa-
bled so no cooking cycles can
be carried out
E32 Faulty drain valve. Inform the after-sales service
The oven’s functions are disa-
bled so no cooking cycles can
be carried out
E33
There is no drain water, or
there is insu cient water pres-
sure during washing.
Inform the after-sales service
The oven’s functions are disa-
bled so no cooking cycles can
be carried out
E34 W
ashing error. Inform the after-sales service
The oven’s functions are disa-
bled so no cooking cycles can
be carried out
Alarm Fault Remedy Notes