EasyManuals Logo

Arbiter Systems 1092A User Manual

Arbiter Systems 1092A
214 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #150 background imageLoading...
Page #150 background image
132 Options List
RS-232, NTP Setup
The RS-232 port uses an RJ-11 style connector, which is configured as a DTE device with the
following pin out:
GND = Pin 2 TXD = Pin 3 RXD = Pin 4 GND = Pin 5
10/100 Base-T
Option 32/33 uses the standard 10/100 base-T connection for connecting to an Ethernet. Fig-
ure C.11 indicates the location of pin 1 (two places for Option 33).
TXD+ = Pin 1 TXD– = Pin 2 RXD+ = Pin 3 RXD– = Pin 6
Status LED’s
There are three active status LED’s on the rear panel of Option 32; six active LED’s on the Option
33. The LED’s are Link (green), Synch (green) and Error (red). Option 32/33 will perform an
initial self test when powered on. After the initial self-test phase, where all status LEDs should be
lit, the LED’s indicate the status of the NTP Server.
Link LED
Link (green) LED on: Ethernet 10/100 base-T connection is good.
Synch LED
Synch (green) LED on: synchronized to the time signal, correct reception of time data, requires
the satellite controlled clock to be synchronized.
Synch LED flashing 50% duty cycle: Some information received, but not yet synchronized
reliably.
Error LED
If the Error LED is on or blinking the Synch LED will give a diagnostics code.
Error (red) LED stable on, Synch (green) LED flashing
1x: EPROM-checksum error
2x: RAM-error
3x: Network controller error
4x: EEPROM checksum error, or is bad
5x: IP address already used on network
Error LED flashing, Synch LED flashing
4x: Faulty network connection
5x: No DHCP response was received

Table of Contents

Other manuals for Arbiter Systems 1092A

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Arbiter Systems 1092A and is the answer not in the manual?

Arbiter Systems 1092A Specifications

General IconGeneral
BrandArbiter Systems
Model1092A
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals