EasyManuals Logo

Arcom SBC-GX1 User Manual

Arcom SBC-GX1
114 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #27 background imageLoading...
Page #27 background image
SBC-GX1 Technical Manual Award BIOS setup
Option Explanation
Load BIOS Defaults
Used to revert to the original factory-assigned BIOS settings.
These are the most stable values for the system. Use them if
the system is performing erratically due to hardware problems.
When you select this option you are prompted:
Load BIOS Default (Y/N) ?N
Enter Y to replace you current settings with the BIOS defaults.
Load Setup Defaults
Used to revert to the setup default values. These are the ‘best
case’ values for the system, and should provided optimum
system performance. When you select this option you are
prompted:
Load Setup Default (Y/N) ?N
Enter Y to replace you current settings with the Setup
defaults.
Integrated Peripherals
Used to configure the IDE hard drive and programmed input /
output features. See page 39
Password Settings
In the BIOS Features Setup, you can specify that a password
is required every time the system is rebooted, and/or to enter
the Setup utility. (You do this using the Security Option - see
page 31
for details.)
If a password is required, you can use this option to set and
change the password that must be entered. You are prompted:
Enter password:
Enter the password you require using up to eight characters,
and confirm it when prompted. You can cancel this process at
any time by pressing Esc. The new password overwrites any
password previously used.
IDE HDD Auto Detection
Used to automatically configure hard disk parameters. When
you select this option, auto-detection starts. Details of the first
hard disk drive are displayed, and you are prompted:
Do you accept this drive C: (Y/N)?
To save the details detected, enter Y. The system then
searches for further hard disks. Alternatively, press N to
continue without saving the details.
Save & Exit Setup
Saves any changes you have made to the CMOS, and exits
the CMOS Setup Utility.
Exit Without Saving
Cancels any changes you have made to the CMOS, reverting
to the previous settings, and exits the CMOS Setup Utility.
© 2004 Arcom Issue D 27

Table of Contents

Other manuals for Arcom SBC-GX1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Arcom SBC-GX1 and is the answer not in the manual?

Arcom SBC-GX1 Specifications

General IconGeneral
BrandArcom
ModelSBC-GX1
CategoryMotherboard
LanguageEnglish

Related product manuals