SBC-GX1 Technical Manual Operating System drivers
Operating System drivers
The support CD contains drivers for XpressGraphics
TM
, XpressAudio
TM
, PCI Bridge,
UDMA Bus mastering IDE controller and DP83815 Ethernet controller. The following
sections provide details for installing these drivers for Windows 98 and NT4. The CD
also contains drivers for some other operating systems - See the documentation on the
CD for more details.
Windows 98 driver support
Before installing Windows 98 power up the board and enter the Setup utility by pressing
the Del key during the POST. In the BIOS features screen set the boot sequence to
,CD-ROM, C, A’, and in the
Chipset features setup screen (see page 34) enable USB
support if required. Close the Setup utility, saving the changes.
Insert the Windows 98 CD into the drive and reboot the system. Install Windows 98,
following the instructions provided in the Windows 98 user manual.
When Windows 98 has been installed, insert the support CD and follow the steps
detailed below to install each driver.
XpressGraphics
TM
video driver
1 In the Control Panel, select System → Device Manager and choose Display
Adapters.
2 Select Standard PCI VGA adapter and click on Properties.
3 Select the Driver tab and click on Update driver.
4 Select Search for a better driver.
5 Select Other location.
6 Select the path D:\Win98\Video and click on OK.
7 Wait while the driver installs. When this process is complete, click on Finish.
8 When prompted, click on Yes to restart your computer.
9 Check that the driver is present. In the Device Manager, look under Display
Adapter for ‘XpressGraphics’. If it’s not present repeat the procedure.
© 2004 Arcom Issue D 54
To Next Page
Loading...
Need help?
General
