SBC-GX1 Technical Manual Operating System drivers
5 Specify the I/O, IRQ and DMA settings (the driver does not auto-detect them.
These must be identical to the settings specified in the BIOS features setup
screen in the Setup utility (see page 31
). The default settings are:
Audio I/O Base Address 220H
MPU-401 I/O Base Address 330H
Audio IRQ Select IRQ5
Audio Low DMA Select DMA 1
Audio High DMA Select DMA 5
National Semiconductor DP83815 Ethernet driver
1 In the Control Panel, select Network and go to the Adapters tab.
2 Click on Add and then Have Disk.
3 Enter the path D:\WinNT\Ethernet and click on OK.
4 Select National Semiconductor Corp DP8315 10/100 Macphyter3v PCI and click
on OK followed by Close.
5 Select the protocols you require. When prompted, insert the Windows NT
installation CD-ROM into the drive. Complete installation as described in the
Windows NT documentation.
UDMA installation
1 In the Control Panel, select SCSI Adapters and go to the Driver tab.
2 Remove the existing driver (ATAPI).
3 Click on Add driver.
4 Enter the path D:\WinNT\UDMA.
5 Enter the location D:\ when prompted and click on OK.
6 When prompted, click on Yes to restart your computer.
© 2004 Arcom Issue D 59
To Next Page
Loading...
Need help?
General
