5.9 Ethernet connector
The MPS2 and MPS2+ FPGA Prototyping Boards provide one 100Mb/s Ethernet connector.
The Ethernet connector connects to the MAC/PHY on the MPS2 and MPS2+ FPGA Prototyping Boards.
The MAC/PHY connects to general‑purpose pins on the FPGA. The availability of the Ethernet function
depends on the design which you implement in the FPGA.
The following figure shows the Ethernet connector J31.
Figure 5-13 Ethernet connector
Related information
2.10 Ethernet interface on page 2-34
1.3 Location of components on the MPS2 FPGA Prototyping Board on page 1-17
1.4 Location of components on the MPS2+ FPGA Prototyping Board on page 1-19
5 Signal Descriptions
5.9 Ethernet connector
100112_0200_09_en Copyright © 2013–2016, 2018–2020 Arm Limited or its affiliates. All
rights reserved.
5-88
Non-Confidential
To Next Page
Loading...
Need help?
General
